How to tie-dye: the seven steps behind every pattern

By Mike Fowler · October 1, 2026

How to tie-dye: the seven steps behind every pattern

Every tie-dye pattern, from a simple scrunch to a sixteen-petal mandala, follows the same rhythm. Master it once and the folds become variations on a theme. You are only ever learning one new thing per technique: the fold itself.

1. Scour your fabric

Pre-wash new fabric in hot water with Synthrapol and a little soda ash to strip factory finishes, oils and optical brighteners. They block dye and cause blotches. How to scour.

2. Mix chemical water and dye, and choose your soda ash method

Dye goes into chemical water, not plain water. Then decide whether to pre-soak the fabric in soda ash or mix soda ash into the dye. Chemical water recipe and soda ash methods.

3. Dampen evenly

Lay the fabric flat and mist it until it is uniformly moist but not dripping. Damp fabric sticks to itself and to the table, which is what makes clean folds possible, and it makes every layer take the same pattern.

4. Fold and bind

This is the technique itself, the only step that changes from pattern to pattern. Bind with cotton string, snug but never very tight. Start with the Scrunch or the Spiral.

5. Apply the dye

Use squeeze bottles and work color into the folds. If dye is not dripping out of the underside, you have not used enough.

6. Cure

Wrap the piece in plastic and leave it somewhere warm for 12 to 24 hours. This is where the chemical bond actually completes. Rushing it is the second most common mistake after skipping soda ash.

7. Rinse and wash

Rinse cold while still tied, untie and keep rinsing, then machine wash hot. The full wash-out.

That is the whole process. Scour, mix, dampen, fold, dye, cure, rinse. The other steps never change, which is what makes you fast.

Every fold, recipe and fix in this article comes from Art of Tie-Dye, Mike Fowler's complete guide to folding, tying and dyeing.

Comments